A “part” is a mapping between a “symbol” (which represents the connectivity within a schematic) and a “cell” (which is the device footprint on a printed circuit board)
Electronics Product Design Sevices
- Home
- /
- Expedition
Embedded PCB
- 3EQHM57
- AZ1117B
- SE2528LData sheet
- AS179-92LFData sheet
- Data sheet 74LVT162245Data sheet74LVT162245
- AWGThe diameter of wires is measured by a standard reference number referred to as the American Wire Gauge (AWG). Figure 4-4 lists some gauge values and the equivalent diameter. From the diameter and assuming copper wire, we can estimate the resistance per length. For example, 22-gauge wire, typical in many personal computer boxes, has a […]
- IPC 2221
- HOW TO DESIGN BUCK CONVERTERDesign Buck Regulator How to calculate the design parameter
- PCB DESIGN
- MOSFET